Solve the dripping faucet problem once and for all

Everyone at some point must have suffered from the dripping faucet problem. After all, with use it is common for the faucet to become somewhat weak, which can happen after a few months of use. But if you think you need a plumber to solve the problem, learn about these tips that will solve your problem in a few minutes and without the help of a professional.

See more: Learn how to clean the stove burner with this homemade 2-ingredient mixture

use white tape

The most efficient tip for these cases is the use of white tape, which will be useful to seal the faucet opening. Therefore, do a brief analysis and see if your faucet handle is loose, because if so, it means that it lacks strength or pressure.

Then, remove the doorknob completely and then wrap the screwed part with the white tape. This will be important so that the handle can be fully fixed and exert pressure when closing.

But don't use too much white tape, as too much can have the opposite effect and prevent you from being able to turn off the faucet. Therefore, only give it one or two turns for the seal to be useful and perform the function of keeping the faucet properly closed.

Solve the dripping faucet problem

If you've already done the white tape process, but it wasn't enough to stop the water from coming out, then maybe it's time to roll up your sleeves. Therefore, close the water transmission or the general register.

Soon after, turn on all the faucets in the house that have the same general valve and use the flush. This will be important so that you can remove all air bubbles, which can harm the pipeline.

And then, have a new sealing rubber on hand. To change it is very easy, as you just need to remove the handle and locate the rubber, usually black, inside. And then, replace the rubbers and put the faucet back, then release the general register and test.

However, if you have not been able to solve the problem, note if the faucet wall is wet. Because in that case, there may be some persistent infiltration in your pipeline and for that you will need to call a professional.